|
Thin plywood (cardboard is still little floppy) and then stainless steel sheet reinforced by 4-6 fences... there are 5 strong fixing points at the rear (3 diffuser, 2 bumper), 4 on the sides (bumper), 2 at the middle (heat shields points, I will create a holder with a single fixing point, most likely just a bended sheet with a slip on thread) and finally 2 points at the differential/support subframe (drill 2 holes, thread or any fitting).
__________________
"If everything seems under control, you're not going fast enough.” Mario Andretti
|